Installation method of deep groove ball bearing

Time: 2018-10-31
Summary: Installation method of deep groove ball bearing: i: press fit. ii: heating coordination

Installation method for deep groove ball bearings  i: press fit

Bearing inner ring work closely with the shaft, the outer ring and bearing hole is a loose fit, press the bearing to be pressed on the shaft are available, and then put the shaft together with the bearing load bearing hole,when pressed on the bearing inner ring end face, cushion the assembling casing made of a soft metal material (copper or mild steel), bearing outer ring and bearing hole tight fit, inner ring and the shaft is relatively loose fit, the bearing can be pressed into the bearing hole first, then assembling casing diameter should be slightly less than the diameter of a hole. If the bearing ring is closely matched with the shaft and seat hole, the inner ring and outer ring should be pressed into the shaft and seat hole at the same time during installation.The structure of mounting sleeve should be able to press the end surface of the bearing inner ring and outer ring at the same time.

Installation method of deep groove ball bearings   ii: heating coordination

By heating the bearing or bearing seat, the use of thermal expansion will fit into a loose fit installation method is a kind of common and labor-saving installation method, this method is a bigger bearing the English interference quantity of installation, the bearing before heating or separable bearing ring into the tank of uniform heating in the 80-100 degrees Celsius,and then loaded on the shaft, as soon as possible out of the oil to prevent inner ring after cooling end face and the shoulder joint is not tight, bearing after cooling can be used when outer ring and light metal bearing seat close coordination with the heating and the hot charging method of the bearing, can avoid the mating surface scratch. Heating tank with bearing and place should have a certain distance from the bottom of a layer of gate, or hanging hooks in the bearings, bearing on the bottom, in case of heavy impurities into the bearing or uneven heating, fuel tank must have a thermometer, strictly control the oil temperature shall not exceed 100 degrees Celsius, in order to prevent the tempering effect, reduce the hardness of the ring.

SYW since 1999has been focusing bearing trading for nineteen years.sunbearingDiscount and Promotion all bearing  Self-aligning Ball Bearing  Spherical Roller Bearing  Thrust Aligning Roller Bearing  Tapered Roller Bearing  Thrust Ball Bearing Deep Groove Ball Bearing Angular  Contact Ball Bearing  Thrust Roller Bearing  Pillow Block Bearing  Thrust Conical Roller Bearing  Bearing Cage

Previous: How to Install a Pillow Block Bearing

Next: Installation of taper roller bearings